Muy buenas. Por favor, necesito ayuda con este pedal de cambio de canal. (Creo que se llama así). Me he hecho con tres amplis pequeños y necesitaba un pedal de cambio de canal desde una guitarra a tres amplis. Encontré este en una tienda de Madrid y me lo recomendaron, así que me lo llevé puesto. Al llegar a casa y ponerme a leer las instrucciones, entre mi bajo nivel de inglés, el lenguaje técnico y que no tengo ni idea de electrónica comenzaron a surgir las dudas. Mis dudas principales son que no sé si este pedal, además de cambiar de un ampli a otro, permite conectar dos o tres amplis a la vez. Yo pulso los tres botones y se oyen los tres amplis, pero en las instrucciones creo entender que no se puede y que hace falta otro pedal split o algo así. No llego a entenderlo. También tiene un botoncito: Ground, que no entiendo para nada para qué sirve, ni si debe estar pulsado o no, y si debe estar pulsado en qué situaciones y para qué sirve, etc. Dice algo de tierras de ruidos y demás, pero no entiendo nada. Sobre este botón, el manual dice:
4 The grounds of Outputs A, B and C are connected to one another when this switch
is pressed. This is useful when you want to switch between channels of one amp.
Press this Ground switch if you want to route Outputs A, B and C to various amps
simultaneously; the outputs are then no longer electrically isolated, however, i.e., one
output (e.g. Output A) must be connected directly to the amp. For every other output
used for an amp, a transformer (e.g. the Lehle P-Split) should be interposed, in
order to avoid hum loops.
This Ground switch must remain pressed at all times in countries in which the amp
power supply is only two-core.
The Outputs A, B C are set to low impedance during switching when the Ground
switch is pressed, in order to suppress the natural switching noise of the gold-plated
relay contacts. This is accomplished under software control by means of the built-in
microcontroller. This circuit has absolutely no influence on the sound during normal
operation, i.e., when no switching is taking place, since it is not located in the signal
path.
Podría alguien ayudarme a entender cómo funciona este pedal.
Muchísimas gracias de antemano.